Morse Taper Tool Holders
1.High quality elastic steel material with long use time.
2.Shank of the Straight Shank Collet Chuck: 10mm, 12mm, 16mm, 20mm, 25mm, 32mm, 40mm.
3.Suitable Collet:ER11/ER16/ER20/ER25/ER32/ER40
4.The precision little than 0.01mm with balance 10,000rpm. Higher precision also can be made by your demand.
5.Holder hardness:48-55HRC
6.The protrusion length is difference from 20mm to 200mm.
7.Suitable NUT & Wrench is also upon request.
MT Tool Holders,MT Collet Chuck,MT Series Holders,Morse Taper Collets Holders SISHUI TELI TOOL CO.,LTD. , https://www.er-collets.com
Problem 1: Check if the connection cable between the graphics card and the monitor is loose. Poor contact LCD screen will appear "clutter", "noisy" phenomenon.
Solution: The above situation occurs because the connection line between the LCD splicing screen and the graphics card has become loose. As long as the connection line is firmly connected, the situation of "clutter" and "noise" can be improved.
Question two: Check whether the video card overclocking is excessive, overclocking the use of excessive screen will appear irregular, intermittent horizontal stripes solution, check the video card is excessive overclocking, if the graphics card overclocking often occurs above, then should be appropriate to reduce overclocking The magnitude, but pay attention, first reduce the frequency of video memory.
Question 3: If Huaping appears, but after the above two strokes do not take effect after use, it is necessary to check the quality of the video card.
As a solution, the user can check whether the anti-electromagnetic interference and electromagnetic shielding quality of the graphics card pass. The specific method is: Place some components that may produce electromagnetic interference away from the video card installation (such as hard disk) as far as possible, and then see if the video screen disappears. If it is determined that the electromagnetic shielding function of the graphics card is off, the graphics card should be replaced, or the shielding mask should be made.
Question 4: Check the display resolution, monitor resolution or refresh rate is set too high,
If the solution exceeds the default resolution of the manufacturer's display screen, the screen may also appear.
With the development of science and technology, LCD splicing technology has become more mature, but many LCD manufacturers, LCD screen quality technology is also uneven, so Emperor Ai Di reminds you: when choosing the LCD screen must choose the quality of credit technology are passing ! Only such product quality is more secure. Here are a few small ways to deal with the LCD screen splicing to everyone, after the encounter Huaping problems, I hope to be helpful to everyone.
September 05, 2019