Before installing the metal tube float flowmeter , be sure to clean the welding slag and debris in the pipeline. In order to ensure the measurement accuracy of the metal tube floater flowmeter , a straight pipe section of not less than 10DN shall be added at the inlet end of the flowmeter, and a straight pipe section of not less than 5DN at the outlet end. The adjustment control valve must be installed downstream of the flowmeter when measuring. . If the medium to be measured is a large pulsating flow or two-phase flow, a buffer shall be installed at the upstream of the metal tube float flowmeter to eliminate or reduce the pulsation, so as to ensure that the flow of the medium is single-phase stable, and at the same time, it is recommended that the flowmeter be best used. Damping type. If the measured medium is dirty or contains magnetic particles, a filter or magnetic filter should be installed upstream of the metal tube float flowmeter .
Flake ice is widely used in the following field.
â— Seafood Processing
â— Meat Processing
â— Fresh Preservation
â— Concrete Cooling
â— Snow Making
â— Medical Facilities
â— Supermarket
â— Environmental Engineering
Snoworld flake ice production capacity (tons/24 hours) is 0.5, 0.75, 1, 1.2, 1.6, 2, 2.5, 3, 5, 6, 8, 10, 15, 20, 25 and 30. The ice flake thickness is within the range of 1.5 to 2.2 mm. The ice flake comes out dry with a low temperature is around -7 C degree. Thus, it is not easy to melt and get lumped. Both fresh water and sea(brine) water can be used for ice making, and both environment of on land and on board is suited.
Snoworld Flake Ice Machine has several features.
â— Designed and manufactured under the pressure vessel standard, thus making this product durable, safe and reliable.
â— Optimized system design ensures the machine work stably with a low failure rate.
â— Complete product series to meet different application.
â— With CE(PED)/ASME certificate.
Flake Ice Machine Flake Ice Machine,Commercial Flake Ice Machine,Industrial Flake Ice Machine,Flake Ice Making Machine Fujian Snowman Trade Co., Ltd. , https://www.sinoicemachine.com
The installation of metal tube float flow meters should be able to properly support the vibration of the pipeline or reduce the axial load of the flowmeter, otherwise the support of the fixed flowmeter should be increased. In order to facilitate the maintenance and repair of metal tube float flowmeter, cleaning of magnetic filter and regular maintenance of user's pipeline, when the metal tube float flowmeter is used for gas measurement, it should ensure that the working pressure in the pipeline is not less than 5 times of the flow The pressure loss of the meter allows the flow meter to stabilize and operate normally. Before using the remote transmission and metal tube float flowmeter with alarm limit switch, open the meter cover and wire it correctly according to the wiring diagram. For the alarm-type screw that loosens the limit switch, the user sets the limit alarm position as required, and tightens the screw to use it after recovery.
August 19, 2019